May 15, Your Blade mSR BNF comes from the factory completely assembled and flight tested. It includes 2 electronic installation and setup while providing heading lock-like gyro performance .. Spektrum DX7/DX7se. JR X programming values are shown below for the Spektrum DX6i, DX7s, DX6, DX7, DX8, the Blade mSR S DXe model setup available at Sep 25, A short course – How to Bind and Trim Your mSR Heli. The new E-flite mSR ultra micro helicopter is truly something different and exciting for RC.
|Published (Last):||20 June 2012|
|PDF File Size:||1.39 Mb|
|ePub File Size:||18.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
You explain things well, and you seem to hit on the important things that I really need to know. With your tips, I’ve got bldae mSR “locked-in” with stock parts and thus considerable cost and weight savings. Friendly personal support should you need it.
How-To Setup, Bind and Trim the Blade mSR BNF
Posting Quick Reply – Please Wait. Click Here For More Information. BB code is On. I was a little nervous, but had to try it outside.
Pay special attention to polarity! Did I mention this was my first Heli and I absolutely could not fly it until I read your e-book?
Once you’re programmed for HELI, you can use a throttle curve and throttle hold. Good thing I am on holidays next week – once again, thanks! I can’t wait to try out your settings on a better radio to really have a blast with this little helicopter. Originally Posted by copperclad Hi with all due respectyou absolutely can use heli modesand many people are doing it with great successyou just have to select 1 servo normal in your swash setup screenwhich is the same as acro in that there is no servo mixingthe nice thing about using heli mode is that there are options designed for helislike throttle curveand throttle holdas opposed to acro mode where you just have V tail and flaperonscheers.
Sep 05, Yeah, you can use the 1 servo setup. There are some simple steps to take when you get ready to fly it. Once you are comfortable flying your Blade mSR or SR, you may want to start altering things a bit in the radio programming to make them mimic a true single rotor collective blace helicopter while hovering. I had no idea there was so much you could do with the mSR.
I’d like to know, too. I noticed that it has 2 servo on the helicopter. I think it is one servo. Does it mean you get bladde travel than normal? But everything for the beginner is there in your manual.
Hours of internet searching – still none the wiser. The first was a cheap Chinese coax that I couldn’t get to do anything, I then purchased a Blade cx Scout which I still enjoy.
The little sucker is my first and it flies really well. It’s snowing here, so I’m stuck flying in my living room, and these adjustments make for better practice and more fun! Our video is going to emphasize three bullet points: Hi Jim glad to helpi know switching to a new TX can be frustrating at firstjust holler if you get stuckcheers.
MSR DX7 Settings – HeliFreak
All that said; here is a simple modification I have experimented with to my flybar on my mSR. I thought about adding more sub-trim but that would defeat the purpose and it probably doesn’t help that my negative expo on the rudder is set tocuz i noticed a sfttings difference in how much more the tail motor works but its pretty well dialed seftings to my likings.
I am still learning, but because of your book I didn’t look like a beginner!! Add a Poll to this Thread. What they were describing using the airplane mode would work for you.
Hope this helps you guys.